5 receiving data from personal computer – Furuno BACK GP-80 User Manual
Page 60

8-8
8.5 Receiving Data from
Personal Computer
Loading Waypoints/Routes data
Waypoints and Routes data can be down-
loaded from a personal computer, through the
DATA 4 connector.
1) Press [MENU ESC] [9] and [5].
2) Press ▲ or ▼ to select Level.
3) Press t or s to select level of personal
computer; RS232C or RS422.
4) Press the [NU/CU ENT] key.
5) Press s to select Com.
6) Press ▼ to select To Next Page. The DATA
4 I/O SETUP menu appears.
Figure 8-12 DATA 4 I/O SETUP menu (2/2)
7) Press ▲ or ▼ to select Baud Rate.
8) Press t or s to select baud rate; 4800bps,
9600bps, or 19200bps.
9) Press the [NU/CU ENT] key.
10) Press t to select WPT/RTE.
11) Press ▼ to select Command. Stop, on the
same line as Command, appears in reverse
video.
12) Press s to select Start. The message
shown in Figure 8-13 appears.
Figure 8-13
13) Press the [NU/CU ENT] key. The mes-
sage shown in Figure 8-14 appears while
data is being loaded.
Figure 8-14
14) Operate the computer to output data.
When data is loaded, the cursor shifts to
Stop.
15) Press the [MENU ESC] key. When data
is loaded successfully, The message in
Figure 8-15 appears.
Figure 8-15
If data could not be loaded, the message
shown in Figure 8-16 appears.
Figure 8-16
Stopping loading of data
1) Press the [MENU ESC] key. The message
shown in Figure 8-17 appears.
Figure 8-17
To Previous Page
Baud Rate 9600 bps
Command Stop Start
Save Data WPT/RTE
Command Stop Start
DATA 4 I/O SETUP
MENU : Escape
ENT : Enter
: Select
Load Data
L.House*
WPT/RTE
WPT
*: Not used.
Loading erases current data
and stops Route navigation
Are you sure to load ?
ENT: Yes MENU:No
Now loading
Waypoint/Route data !
MENU:Stop
Loading ended successfully
Press any key
Failed in loading
Invalid data
Press any key
Are you sure to stop ?
ENT: Yes MENU:No