FOCUS Enhancements FOCUS FireStore FS-4 Pro - Manual (Page 84)

FS Functions
68 FS-4 HD and FS-4Pro HD Portable DTE Recorders
• TC REGEN FS-4Pro HD only
When the FS-4Pro HD powers up in
TC REGEN
mode, it:
• Reads the timecode of the last track recorded.
• Adds 1 to the number.
• Stores the new timecode as the number that will be
assigned to the first frame of the next recording session.
If the drive is empty, i.e. no existing recordings, the
FS-4Pro HD uses the
TC SET
value.
TC SET
FS-4Pro HD only
The Timecode Set parameter stores a user defined timecode in
the FS-4Pro HD’s non-volatile memory. This value is available
for use by the FS-4Pro HD immediately after exiting
TC SET
.
• TC FREE RUN
FS-4Pro HD only
The FS-4Pro HD uses this value on the next recording
after it is set in
TC SET
.
• TC REGEN FS-4Pro HD only
This is the starting value when using an empty hard
disk drive for recording.
• TC REC RUN
This is the value used to begin every recording session
after a power cycle.
TC SET and UB SET Can Be Set at the Same Time
Both parameters, TC SET and UB SET, may be set and are not mutually
exclusive as in some groups, i.e. LCDLIGHT.
TC SET
00 : 00 : 00 : 00
HH : MM : SS : FF
BACK