beautypg.com

A.2 command messages – FUJITSU Solaris PCI GigabitEthernet 3.0 User Manual

Page 70

background image

A.2 Command Messages

Message

Meaning

Workaround

fjgi_device_check: fjgi_hw_init
failed !

An error occurred during
initialization of the adapter.

There is a possibility of
hardware abnormalities.
Please replace the

adapter.

pci_config_setup_failed

The driver could not allocate
sufficient PCI configuration
space.

There is a possibility of
the resource shortage or
hardware abnormalities.

Please check the memory
usage and adapter
installation status.

Autonegotiation_failed

The Auto-Negotiation of

1000BASE-SX failed.

Check the transmission

mode and the adapter
hardware.

A.2

Command Messages

Messages from the /etc/opt/FJSVla/bin/fjla command are listed in TableA.2 ("XX" indicates
user input value.)

Table A.2 Command Message

No

Message

Cause

Workaround

1

fjla init: The number of
members (including

aggregator-interface) is max
8.

More than 8 interfaces
were specified for an

aggregation group.

Specify less than or equal
to 8 interfaces (including

aggregator-interface).

2

FJ LinkAggregation now start.

LinkAggregation has been
started normally.

There is no problem.

3

fjla init: "XX" does not
support FJ LinkAggregation.

The interface "XX" doesn't
support the
LinkAggregation feature.

If the interface is fjgi,
check the patch level of
the driver.

4

fjla init: "XX" vlan
interface cannot define FJ
LinkAggregation.

VLAN interface "XX" can
not be used for the
LinkAggregation feature.

By setting up the physical
interface to use
LinkAggregation, the VLAN
interfaces associated with
the physical interface

also use LinkAggregation.

5

fjla init: A member interface
has already been plumbed.

The interface specified as
a LinkAggregation group
member is already plumbed.

Unplumb all member
interfaces except the
aggregator-interface.

6

fjla init: "XX" is not plumbed
interface.

"XX" interface specified
as an
aggregator-interface is
not activated.

The interface specified as
an aggregator-interface
must be activated
(viewable by ifconfig -a).

7

fjla init: Input member is
duplicated.

The instance number is
duplicated in the
specified member list
(including

aggregator-interface).

Do not specify the same
instance number in the
LinkAggregation member
list (including

aggregator-interface).

63