FUJITSU Solaris PCI GigabitEthernet 3.0 - Manual (Page 59)

Chapter 4 LinkAggregation Feature
● The /etc/hostname.fjgiXX (XX: instance number) file is required for the
aggregator-interface only (in the above example, /etc/hostname.fjgi1 is required).
The LinkAggregation group defined in the configuration file is activated by
rebooting the system.
4.2.2 Using the /etc/opt/FJSVla/bin/fjla Command
The fjla command has the following functions.
● Activate a LinkAggregation Group (fjla init)
● Inactivate LinkAggregation Group (fjla term)
● Display status and statistics (fjla stat)
4.2.2.1 Activate a LinkAggregation Group (fjla init)
This section explains the fjla init command for activating a LinkAggregation group.
- Synopsis
/etc/opt/FJSVla/bin/fjla init aggregator-interface member-instance [: member-instance ]
distribution-mode
aggregator-interface : Aggregator-interface name (including instance number)
member-instance : Instance numbers of member interfaces
distribution-mode : Distribution mode used by the LinkAggregation group. One of the
following values must be specified:
1: Destination MAC address distribution
2: Destination IP address distribution
3: Source/Destination IP address distribution
- Description
Configure and activate the LinkAggregation group. All VLAN interfaces associated with the
aggregator-interface will be automatically configured in the group.
- Exit code
0 : normal end.
>0 : error end.
- Example
Configure and activate the LinkAggregation group with the following:
Aggregator-interface: fjgi0
Member-instance: fjgi1 fjgi2
Distribution-mode: Source/Destination IP address distribution
52