FUJITSU Solaris PCI GigabitEthernet 3.0 User Manual
Page 42
3.3 Operation Mode Setup
parameter
status
meaning
lp_10fdx_cap
Read only
The
link-partner
has
been
set
to
10Mbps/FullDuplex by Auto-Negotiation.
0 : Invalid
1 : Valid
lp_10hdx_cap
Read only
The
link-partner
has
been
set
to
10Mbps/HalfDuplex by Auto-Negotiation.
0 : Invalid
1 : Valid
lp_100fdx_cap
Read only
The
link-partner
has
been
set
to
100Mbps/FullDuplex by Auto-Negotiation.
0 : Invalid
1 : Valid
lp_100hdx_cap
Read only
The
link-partner
has
been
set
to
100Mbps/HalfDuplex by Auto-Negotiation.
0 : Invalid
1 : Valid
lp_1000fdx_cap
Read only
The
link-partner
has
been
set
to
1000Mbps/FullDuplex by Auto-Negotiation.
0 : Invalid
1 : Valid
lp_1000hdx_cap
Read only
The
link-partner
has
been
set
to
1000Mbps/HalfDuplex by Auto-Negotiation.
0 : Invalid
1 : Valid
lp_pauseTX
Read only
The link-partner has been set to transmit
pause frame by Auto-Negotiation.
0 : Invalid
1 : Valid
lp_pauseRX
Read only
The link-partner has been set to receive pause
frame by Auto-Negotiation.
0 : Invalid
1 : Valid
lp_autoneg_cap
Read only
The
link-partner
has
been
set
to
Auto-Negotiate by Auto-Negotiation.
0 : Invalid
1 : Valid
role_cap
Read only
The current Role setting when operating at
1000Mbps.
(Not
valid
for
PW008GE4/PW0G8GE1/SE0X7GD2X)
0 : Slave
1 : Master
jumbo
Read only
0 : JumboFrame support disabled.
1 : JumboFrame support enabled.
● About speed/duplex/flowcontrol, it recommends carrying out default operation
(Auto-Negotiation). In that case, connection partner equipment should also enable
Auto-Negotiation. By doing so, it is the optimal. speed/duplex/flow control It
35