beautypg.com

Frymaster FOOTPRINT 8195991 User Manual

Page 27

background image

4-4



5. When the hold-down ring is in position,

if using filter paper, sprinkle one cup of
filter powder evenly over the paper. (See
Figure 4)

If using a filter pad, position the hold
down ring on top of the pad. DO NOT
use filter powder with the pad.

Figure 4

6. Replace the crumb tray in the filter pan, then push the filter pan back into the fryer, positioning it

all the way to the back of the cabinet.


4.2.2 Preparation for Use with the Magnasol Filter Assembly

1. Pull the filter pan out from the cabinet

and remove the crumb tray and
Magnasol filter assembly. (See Figure
5)

The filter pan is equipped with rollers in
rails, much like a kitchen drawer. The
pan may be removed for cleaning or to
gain access to interior components by
lifting the front of the pan to disengage
the front rollers, then pulling it forward
until the rear rollers clear the rails. The
pan cover must not be removed except
for cleaning, interior access, or to allow
a shortening disposal unit (SDU) to be
positioned under the drain.

NOTE: Refer to Section 4.4 for
instructions on how to disassemble and
reassemble the Magnasol filter screen
assembly.


2. Inspect the fitting on the bottom of the

Magnasol filter assembly to ensure that
the O-ring is present and in good
condition. (See Figure 6)



3. Inspect the filter pan connection fitting

to ensure that both O-rings are present
and in good condition. (See Figure 7)

Figure 5

Figure 6

Figure 7

Inspect the filter
screen O-ring.

Inspect the filter
connection fitting
O-rings.