FUJITSU CM71-00329-7E - Manual (Page 21)

11
CHAPTER1 Basic Functions
1.7 Error Jump Function
This section describes the error jump function in SOFTUNE Workbench.
■ Error Jump Function
When an error, such as a compile error occurs, double-clicking the error message displayed in the Output
window, opens the source file where the error occurred, and automatically moves the cursor to the error
line. This function permits efficient removal of compile errors, etc.
The SOFTUNE Workbench Error Jump function analyzes the source file names and line number
information embedded in the error message displayed in the Output window, opens the matching file, and
jumps automatically to the line.
The location where a source file name and line number information are embedded in an error message,
varies with the tool outputting the error.
An error message format can be added to an existing one or modified into a new one. However, the modify
error message formats for pre-installed Fujitsu language tools are defined as part of the system, these can
not be modified.
A new error message format should be added when working the Error Jump function with user registered
tool. To set Error Jump, execute the [Setup] - [Error] command.
■ Syntax
An error message format can be described in Syntax. SOFTUNE Workbench uses macro descriptions as
shown in the Table 1.7-1 to define such formats.
To analyze up to where %f, %h, and %* continue, SOFTUNE Workbench uses the character immediately
after the above characters as a delimiter. Therefore, in Syntax, the description until a character that is used
as a delimiter re-appears, is interpreted as a file name or a keyword for help, or is skipped over. To use %
as a delimiter, describe as %%. The %[char] macro skips over as long as the specified character continues
in parentheses. To specify "]" as a skipped character describes it as "\]". Blank characters in succession can
be specified with a single blank character.
Table 1.7-1 Special Characters for Analyzing Error Messages
Characters Semantics
%f Interpret as source file name and inform editor.
%1 Interpret as line number and inform editor.
%h Become keyword when searching help file.
%* Skip any desired character.
%[char] Skip as long as characters in [ ] continues.