FUJITSU CM71-00329-7E - Manual (Page 120)

110
CHAPTER2 Dependence Functions
2.3.4 Break
The emulator debugger (MB2198) provides nine types of break functions. When by each
break function aborts program execution, the address where a break occurred and the
break factor are displayed.
■ Break Functions
The emulator debugger (MB2198) provides the following nine types of break functions;
- Code break
- Data break
- Code event break
- Data event break
- Trace buffer-full break
- Alignment error break
- External trigger break
- Forced break
- Data watch break
Available break functions depend on the DSU, adapter board, and chip.
*: FR60Lite does not support these functions because they are enhanced by "Code Break (Hardware/
count)", "Sequencer (31evels+restart)", and "Trace Trigger".
Table 2.3-3 Available Break Functions
DSU Adapter FR60Lite FR80S
Code break (software)
❍ ❍ ❍ ❍
Code break (hardware)
❍ ❍ ❍ ❍
Code break (hardware/count)
✕ ✕ ❍ ❍
Data break
✕ ✕ ❍ ❍
Code event break
❍ ❍ ✕
*
✕
Data event break
❍ ❍ ✕
*
✕
Trace buffer-full break
❍ ❍ ❍ ❍
Alignment error break
❍ ❍ ❍ ❍
External trigger break
❍ ❍ ❍ ❍
Forced break
❍ ❍ ❍ ❍
Datawatch break (hardware)
✕ ✕ ❍ ✕
Datawatch break (software)
❍ ❍ ❍ ❍