FUJITSU CM71-00329-7E - Manual (Page 206)

196
CHAPTER2 Dependence Functions
2.4.8.1.2 Trace Data Display Example (Instruction)
This section describes trace data that is displayed in the instruction mode.
■ Instruction Display
This mode displays the branch addresses of the RAW data display in disassembly format. Figure 2.4-14
shows an instruction display example.
Figure 2.4-14 Instruction Display
The instruction display mode displays the following information in addition to the information displayed in
the RAW data display mode.
mnemonic
Displays disassembly of the instructions that are executed between branch addresses.
In complementary lines, information ranging from "b-cause" to "reset" is not displayed.
Like [RET] shown in Figure 2.4-14 if the mnemonic instruction is enclosed in brackets [ ], it means that
the instruction may not be executed.
[Exception]: The instruction is not executed.
[INT instruction]: The instruction is executed.
Note:
For branch addresses (b-addr), an instruction between the branch addresses is extracted to get the
frames to complement each other by disassembly. When they are complemented, the frame number
field is blank.