Hoover S1211 - Manual (Page 15)

K
Insert the tool so that the button
on the tool fits into the slot in the
end of the hose grip.
Turn the plastic ring as shown to
lock the tool in place. To remove
tools, reverse the procedure.
For additional length, attach one
or both* wands to the hose as
described above.
Tools attach to the wand(s)* in
the same manner.
*Available with deluxe set only.
D. Make cleaner adjustments
When using the cleaning tools, the adjustment for carpet pile height
should be set according to the surface on which the cleaner is standing.
This will give added stability when using the tools. Set the adjustment
for pile height to LOW if using the cleaning tools in an area where there
are bare floors and use SHAG in carpeted areas.
Place the cleaner handle in the upright position, plug cleaner into the
electrical outlet and push switch to the “NORMAL” position. Your
cleaner is ready for use for cleaning above the floor and in hard to reach
areas.
To clean tools
To clean the hose wipe off dirt with a cloth dampened with a liquid deter-
gent. Rinse with a damp cloth. Cleaning tools may be washed in warm
water with a detergent. Rinse and let dry before using.
14