Project load, All notes off – Arturia BeatStep Pro MIDI/Analog Controller and Sequencer Kit with CV/Gate Cables (Black) User Manual
Page 28
2.5. Project Load
!: If you need to, be sure you have saved the current Project before you load in a new one, because
doing so will replace all of the patterns of all three sequencers and will also load a new set of Control
Mode assignments. Be sure this is what you want to do!
When you press the PROJECT button one of the Step buttons will be lit red. This helps you
know which Project is currently loaded into memory. To select a new one, simply hold the
PROJECT button and then press the Step button that corresponds to the Project number you
want to load.
♪
: There’s a preference in the
where you can specify whether the new
Project should be loaded instantly or wait until after the Drum sequencer reaches the end of its current
pattern. See the
section to learn about this feature.
2.6. All Notes Off
It’s possible for a MIDI message to be interrupted for some reason. This can result in a stuck
or ‘hanging’ note on the target device.
If this happens, just press the BeatStep Pro STOP button quickly three times in a row. It will
then send an All Notes Off command over MIDI.
You can also send an All Notes Off command from a computer or another device and the
BeatStep Pro will shut off all of the notes on its three sequencers.
Selecting Project 03
23
Arturia - User Manual BeatStep Pro - Basic Operations