Arturia BeatStep Pro MIDI/Analog Controller and Sequencer Kit with CV/Gate Cables (Black) - Manual (Page 16)

1.2.5. Tempo and synchronization
Set the Project tempo here, either with a twist of the RATE/FINE encoder or by tapping the
TAP/METRO button.
The display will normally display the tempo, but it changes temporarily to show encoder
values when editing.
The metronome sends user-definable note data over MIDI, and can be toggled on/off using
the SHIFT and TAP/METRO buttons together.
There are four Sync options which are accessed by pressing the Sync button repeatedly
while the unit is stopped.
For descriptions of the tempo features see the Tempo [p.50] section of the Projects [p.49]
chapter. For the sync features see the Synchronization [p.74] chapter.
1.2.6. Sequencer control
BeatStep Pro provides three independent sequencers: two step sequencers and a drum
sequencer. Each sequencer has 16 patterns available per Project, and the patterns can be up
to 64 steps long. The Mute buttons can be used to bring the sequences in and out of the mix
instantly. And of course the various controls can be used to modify the sequences during
performance.

♪ : The BeatStep Pro will behave as a MDI-to-CV converter while the unit is in Play mode if Sequencer
1 or Sequencer 2 are muted. If Seq1 or Seq2 are not muted while playing, it does not act as a MIDI to
CV converter, but as a sequencer.
There are unique features available for each type of sequencer, so be sure to read the Step
Sequencer [p.24] and Drum Sequencer [p.38] chapters to learn more.
11 Arturia - User Manual BeatStep Pro - BeatStep Pro Overview