Surface mount: installation to a wall/ceiling – Pelco IME3ICM-E In-Ceiling Mount for Sarix Enhanced 3 Series Cameras User Manual
Page 17

C6644M (2/20)
17
SURFACE MOUNT: INSTALLATION TO A WALL/CEILING
1.
Use the supplied surface mounting template to mark the position of the mounting holes, and if using the top conduit entry, mark the cable
feed-through hole.
NOTE:
If not using conduit for the top entry hole, the grommet must be used to maintain ingress protection.
NOTE:
When mounting the backbox, be mindful of the location of the microphone (See Figure 1) so that it is pointed toward areas of interest.
2.
Attach the backbox to the surface:
a.
Using a 1/4” drill bit, drill the mounting holes.
b.
Press in the plastic anchors (supplied) into the holes.
c.
Feed the cables into the backbox:
(1)
If using the side conduit entry, move the conduit plug to the top entry position, tighten completely, and then fasten the backbox
to the anchors with the two M4 x 35 mm screws (supplied with the camera). Feed cables through the side conduit opening and
then attach the conduit to the backbox.
(2)
If using the top conduit entry, feed the cables through the hole in the surface, and then through the top conduit opening in the
backbox. Attach the conduit to the backbox and then attach the backbox to the anchors with the two M4 x 35 mm screws
(supplied with the camera).
3.
Refer to the Connecting the Cables, Positioning the Camera, and Completing the Camera Installation sections before proceeding.