Profoto B10X OCF Flash Duo Kit - Manual (Page 26)

B10
X,
B10
X Plus
26
www.profoto.com
Continuous light
The CONTINUOUS LIGHT setting defines how the continuous light
intensity is adjusted. There are two selectable settings, PROP and
FREE. Factory default setting is FREE.
• PROP: The continuous light intensity is always proportional
to the flash power setting. This setting is recommended if the
continuous light is used as modeling light.
• FREE: The continuous light intensity can be set independent
from the flash power setting. This setting is recommended if the
continuous light is used as video light.
NOTE
For instructions on how to adjust the continuous light when either PROP or FREE is
selected, go to the section “Adjust the continuous light”.
Advanced settings
Ready signal
The READY SIGNAL setting sets how the B10X/B10X Plus indicates
that it is fully recycled after a flash and is ready to flash again. There are
four selectable settings:
• SOUND: The B10X/B10X Plus beeps when it has recycled and is
ready to flash.
• DIM: The continuous light turns off after flashing and turns on
when the B10X/B10X Plus has recycled and is ready to flash.
• SOUND & DIM: The B10X/B10X Plus signals with both SOUND
and DIM.
• OFF: The B10X/B10X Plus doesn’t signal that it is ready to flash.
This is the factory default setting.
NOTE
Test button indicator light always turns off after flash and turns on again when the B10X
is fully recycled.