Profoto B10X OCF Flash Duo Kit - Manual (Page 13)

B10
X,
B10
X Plus
13
www.profoto.com
NOTE
• Disconnect the battery from the power outlet before cleaning or when it is not used.
• Battery should not be left discharged for a longer period. If the battery is deeply
discharged, the charging time can be longer than specified in section Technical data.
• Battery should not be charged while in contact with flammable material like textiles.
• Battery charger indicator blinking amber indicates battery error. Contact a Profoto
dealer for support.
• Do not attempt to recharge a battery which has been left in a hot or cold environment,
such as a car. Let the battery reach a temperature suitable for charging before doing so.
• This battery can only be used with Profoto products and chargers.
• Li-Ion battery specification: 14.4 Vdc, 43.2 Wh/3.0Ah
• Charger specification: Input 100-240VAC 50–60 Hz. 1.2A max. Output 16.8V ~ 3.0A.
Charge temperature
Temperate indoor environment (ca. 20°C / 70°F)
The battery can be charged in a wider temperature range (0 – 45°C /
32 – 113°F), but charging at high or low temperatures may increase the
charging time and/or reduce the battery lifetime.
Discharge temperature
-20 – 60°C / -4 – 140°F.
For optimal performance and battery lifetime it is recommended to
use the battery in a temperate indoor environment (ca. 20°C / 70°F).
Battery storage
If the battery is to be stored for a longer period, it should be charged
half-full before storage. Never store an empty battery for a longer
period, as it may go into a deep discharge state that can damage the
battery cells. After storing a battery for more than 6 months without
using it, it is advised to check the charge level on the battery. If less
than 2 of the battery status LEDs [21] lits up, the battery should again
be charged to half-full before further storage.