Sony WI-1000XM2 Noise-Canceling Wireless In-Ear Headphones (Black) - Manual (Page 18)

18
1 Turn the SELECT knob to move the
cursor to IP under [FROM].
2 Set the start value of the IP addresses to
assign to newly registered cameras.
Turn the SELECT knob clockwise to move the
cursor to the first three digits (for example,
192).
IP: p 192. 168. 0. 100
3 Turn the VALUE knob to set the value.
Turning clockwise increases the value, and
turning counterclockwise decreases the value.
4 Turn the SELECT knob to move to the
next number and repeat step
3 to set
the other numbers.
5 Turn the SELECT knob to move the
cursor to IP under [TO].
6 Set the end value of the IP addresses to
assign to newly registered cameras.
Turn the SELECT knob clockwise to move the
cursor to the first three digits (for example,
192).
IP: p 192. 168. 0. 199
7 Turn the VALUE knob to set the value.
Turning clockwise increases the value, and
turning counterclockwise decreases the value.
8 Turn the SELECT knob to move to the
next number and repeat step
7 to set
the other numbers.
9 When finished making all settings, turn
the SELECT knob to move the cursor to
SETUP IP.
0 Turn the VALUE knob to change NOT
EXEC to EXEC, then press the VALUE
button.
A “WAIT FOR A FEW SECONDS” message
is displayed on the screen.
qa When the message disappears, turn the
VALUE knob to change NO to YES, then
press the VALUE button.
qs Check the camera assignment result
using AUTO IP SETUP >CAMERA
TABLE in the RM menu.
For details about displaying CAMERA
TABLE, see “To check the camera table”
(page 20).
Assignment using AUTO IP SETUP
>ASSIGN CAM
This method is used to assign camera numbers to
cameras that already have a configured IP address.
With this method, you can specify the group
number and camera number of the camera selection
button from which to start assignments.
Camera assignments are made in ascending IP
address order.
For details about the group number and camera
number, see “Selecting a Camera” (page 29).
Note
Only cameras within the same segment can be
assigned.
1 Turn the SELECT knob to move the
cursor to GROUP NUM.
Set the group number for which to begin
assignment.
2 Turn the VALUE knob to set the value.
Turning clockwise increases the value, and
turning counterclockwise decreases the value.
3 Turn the SELECT knob to move the
cursor to CAMERA NUM.
Set the camera number for which to begin
assignment.
4 Turn the VALUE knob to set the value.
Turning clockwise increases the value, and
turning counterclockwise decreases the value.
5 When finished making all settings, turn
the SELECT knob to move the cursor to
KEEP IP.
6 Turn the VALUE knob to change NOT
EXEC to EXEC, then press the VALUE
button.
A “WAIT FOR A FEW SECONDS” message
is displayed on the screen.
7 When the message disappears, turn the
VALUE knob to change NO to YES, then
press the VALUE button.