Quintum Technologies Tenor AS - Manual (Page 80)

6-5 P/N 480-0059-00-10
Chapter 6: Advanced Topic: SNMP/IVR
#
#
#
EVENT Report_Status_Alarm .1.3.6.1.4.1.6618.2.0.4 "Status Events" Normal
FORMAT Received trap:generic #$G specific #$S. $#args:$*
SDESC
Uswcomment
EDESC
#
#
#
EVENT Uswcomment .1.3.6.1.4.1.6618.2.0.0 "Status Events" Normal
FORMAT Received trap:generic #$G specific #$S. $#args:$*
SDESC
Uswcomment
EDESC
• The quintum.exe file is added to the HPOVRoot\bin directory.
• These files are added to the HPOVRoot\bitmaps\C directory:
Tenor_chassis.ico
Tenor_A.ico
Tenor_D.ico
• The quintum.fields file is added to the HPOVRoot\fields\C directory, and is installed and veri-
fied using the "OVW -fields" command.
• The quintum.reg file is added to the HPOVRoot\registration\C directory.
• These files are added to the D:\hpovnnm\symbols\C\Connector directory:
CONNECTOR_QDVOIP
CONNECTOR_QAVOIP
CONNECTOR_QCVOIP
7. HP Openview will then identify and “auto-discover” the Tenor unit as an SNMP agent. An icon
will appear on the screen to represent each Tenor AS unit. See below.
Figure 6-1 Tenor SNMP Agent Icon
Configure Network Manager IP address
Through Tenor AS’s Command Line interface (CLI), you can configure the IP address for the net-
work management site where HP Openview is running. Once the IP address is configured, the Tenor
AS will be able to process and generate traps for existing alarms, which will enable HP Openview to
monitor the Tenor AS unit for alarm states.