MMD Equipment IGR1000 - Manual (Page 16)

MMD PowerPro Inverter Generators • IGR1000P • IGR2000P • IGR2600HP (041715) MMD PowerPro Inverter Generators • IGR1000P • IGR2000P • IGR2600HP (041715) Page 30 Page 31
GROUND
CONNECTION
GROUND
CONNECTION
GROUND
CONNECTION
3. Ground the generators.
4. Start both generators and confirm that both green "RUN" lights are illuminated.
The Smart-throttle system may be used as long as the Smart-throttle setting of
both generators is the same.
5. Securely plug the electrical appliance plug into parallel cable receptacle and
switch on the electrical appliance power supply.
6. Do not use the receptacle on the control panel of the generator. While operating
in parallel, the only AC output is through the receptacle on the parallel cable box.
The required output of the electrical appliance cannot exceed the rated output of
parallel generators.
Shutting off the generators:
1. Turn off the electrical appliance, then pull out the receptacle plug.
2. Turn off the two generators.
3. Disconnect the parallel kits from the generators.
n The parallel cable connectors can only be used with MMD PowerPro Parallel
Power Ready generators (IGR1000P, IGR2000P, and IGR2600HP).
n While connecting the generator and electrical appliance with the parallel output
cable, carefully and safely insert the plug into the receptacle.
n Do not use the receptacles on the control panel of either generator while
operating in parallel. The only AC output is through the receptacle on the parallel
cable box.
n Do not disconnect the parallel cables during operation.
IGR1000P
IGR2000P IGR2600HP
PARALLEL
OUTPUT
RECEPTACLES
PARALLEL OUTPUT
RECEPTACLES
PARALLEL OUTPUT
RECEPTACLES