Digital Alert Systems DASDEC-II MANUAL - Manual (Page 80)

74
Digital Alert Systems: DASDEC User Manual
4.8.3 Custom MSG Forwarding
This page allows a user to enable EAS NET decode custom message forwarding and also gives them control
over how these messages are forwarded. Even if in manual forwarding mode, a user can auto-forward EAS NET
decoded custom messages.
Decoder NET Access Custom Message Forwarding Options
NET Decode Custom Message Forwarding
When this option is enabled, it gives the operator the ability to forward decoded messages from EAS
NET. If this option is left disabled, any custom messages that are decoded over EAS NET cannot be
forwarded.
Setup > Decoder > Custom MSG Forwarding
If the DASDEC does not have any current active custom message alerts there will be a message that
says: No NET access decoded custom messages at this time.
If the DASDEC does have a current active custom message alert, that alert will appear on the right
hand side of this page in red.
If the NET Decode Custom Message Forwarding option is enabled, then more options appear.
Allow message stop from master NET message originator
This option allows the DASDEC that sent a custom message via EAS NET to control when the alert is
stopped on the receiving DASDEC. If this is not enabled, the user would manually have to stop the alert
on the receiving DASDEC (if it is before the alert is done).
Text Message to Speech Options
This drop down menu gives the DASDEC the ability to use a text-to-speech engine on EAS NET
decoded custom alerts. There are three options, Never use message text-to-speech, Use message text-
to-speech only if Audio not present, and lastly, Always use message text-to-speech. Ignore Audio if
present.
Auto-Forward NET decoded Custom Messages
This option gives the DASDEC the ability to auto forward decoded EAS NET custom messages, even if
the DASDEC is in manual forwarding mode.
Setup > Decoder > Custom MSG Forwarding: Options enabled