Lingenfelter L450010197 L450020197 Lingenfelter C5 Corvette Battery Relocation v1.5 - Manual (Page 14)

Inside the battery box, make sure you have the red cable go to the positive side of the battery and the
black cable to the negative side. Make sure ignition and all electrical switches are turned off. Bolt
the cable ends to the battery using the supplied battery lug bolts with 5/16” hex head.
Install the seal in the groove on the lid by starting in a straight area, taking care not to start in a
corner. Begin with the end that is already cut at 45°. Work the seal into the groove with something
round such as a ballpoint pen or center punch. Do not stretch the seal during installation. This could
cause a gap at the overlap after the seal relaxes. When the starting point is reached, cut the seal at a
45° angle to overlap properly. Cut approximately 1/8” long and work the seal in to ensure a tight fit.
When installing the lid, it may be necessary to push down firmly on either side of the latch during
first installation. The seal will conform to the box after about 15 minutes of being latched.
Reinstall wheel guard, carpet, and any other stock parts that you have taken off during this
installation. Check connections on battery cable before starting car.
Page 13 of 21
1557 Winchester Road
Decatur, Indiana 46733
260 724 2552 phone
260 724 8761 fax
www.lingenfelter.com
Congratulations - you have completed the installation process.