Microtel Series 1000EX - Manual (Page 25)

MICROTEL Series 1000EX Dialer
19
Quick Start Procedure
This procedure is designed to get the Series 1000EX dialer operating in a typical manner
with a minimum of programming. All that is needed is a touch-tone phone with a mute
button and a Microtel Series 1000EX.
1. Plug the touch-tone telephone into the Dialer PHONE jack. Take the telephone off-
hook.
2. Turn on the Power Switch and verify the Dialer has power. (Power/Fault light will
pulse with a 95% duty cycle indicating no errors). The Off Hook light will come ON
(red) indicating the unit is ready to accept touch-tone commands from the local
telephone. At this point, press the Mute button on the telephone. This will clear up
all background noise while still allowing touch-tones to be sent.
3. Press the # key on the telephone. The Dialer will respond “System Ready.”
NOTE: Any time you wish to start over, press the # key and listen for “System Ready.”
4. Set Time and Date
z Enter the command 0**60HHMM*, where the actual 24-hour time is substituted
for HHMM. For example, if the time is 1:00 p.m., enter 0**601300*.
z The Dialer will respond, “The time is one three zero zero” for the above example.
z Enter the command 0**61MMDDYY* where the actual date is substituted for
MMDDYY. For example, if the date is January 2, 1997, enter 0**61010297*.
Note that if the year is 2000 or above, simply put the last 2 digits of the year. For
example, the year 2003 would be entered as YY = 03.
z The Dialer will respond, “The date is zero one zero two nine seven” for the above
example.
5. Enter the Telephone Number of the Dialer.
z Enter the command 0**100p**, where p is the telephone number (up to 16 digits)
of the Dialer’s telephone line. For example, if the Dialer is connected to 504-276-
0571, Enter 0**100 5042760571 **.
z The Dialer will respond, “The system telephone number is 5042760571.”
6. Enter Telephone Numbers to Call upon Alarm.
z Enter 0**01np**, where n = 1,2,3,...32 is the dialer’s directory index of telephone
numbers and p is the actual telephone number (including optional escape codes of
up to 60 digits). Example: Telephone Number 02 in the directory is 555-1212.
The command to enter this number is 0**102 5551212**.
z The Dialer will respond, “Telephone number zero two is 5551212.”