ILY SATA DVD/CD Duplicator Controller - Manual (Page 9)

4. Use the scroll buttons to select the command “2. Test” and press the ENT button. The drives will
automatically close trays and begin the test process.
5. Once the test process is complete, the disc trays will eject and the display will read “Test Result: Pass
X, Fail Y, with X being the number of discs that passed the test, and Y being the number of failed
copies. Use discs that have passed the test for the actual duplication.
Load discs and
press ENT to execute
Test
Start simulation
Finish and
and eject discs
Note: The verification process uses a Disc Readability Check to individually check the presence of data on each copy.
This process does not compare the contents of duplicated discs against that of the master. It only verifies that the
duplicated discs are readable.
To start the Copy + Verify process:
1. Power on the machine (if not already on).
2. Eject disc tray of the Source Drive and place the master disc in the designated Source Drive (usually
the top). The “master disc” is the original of which copies are made.
3. Eject disc tray(s) of the Writer Drives and place blank disc(s) on the tray(s). Number of drives used
depends on number of copies desired. It is not necessary to always use all drives.
4. Use the scroll buttons to select the command “3. Copy + Verify” and press the ENT button. The
drives will automatically close trays and begin the copy process.
5. Once the copy process is completed, the tray(s) will open briefly, and then automatically close again
to begin the verify process.
6. Once the verify process is completed, the trays will automatically eject discs that have passed the
Copy + Verify process.
Load discs
and press ENT
Start copying
Copy completed
and start Verify
Finish and eject discs
7
3.Copy + Verify
– This command will perform the copy process, and immediately follow with a verification
process on all target discs. This command is especially useful for audio CD duplication.