ILY SATA DVD/CD Duplicator Controller User Manual
Page 8

Chapter 2 Functions:
There are two operational function modes available. One is “User Mode” which has the most frequently used
duplicator functions. The other is “Expert Mode” which includes all duplicator functions.
2.1 User Mode
1. Copy -
See Page 6 > Section 2.2 Expert Mode > 1.Copy
2. Copy+Compare -
See Page 8 > Section 2.2 Expert Mode > 4.Copy+Compare
3. HDD Manager
- See Page 13 > Section 2.2 Expert Mode > 11.HDD Manager
4. Expert Mode -
Switch to advanced functions in Expert Mode
2.2 Expert Mode
1. Copy -
This command will copy the master disc placed in the designated Source Drive to all target
discs in the Writer Drives. This process burns all information contained on the master disc to the target
discs so the copies are exact duplicates of the master disc.
To Start the Copy Process:
1. Power on the machine (if not already on).
2. Eject disc tray of the Source Drive and place the master disc in the designated Source Drive (usually
the top). The “master disc” is the original of which copies are made.
3. Eject disc tray(s) of the Writer Drives and place blank disc(s) on the tray(s). Number of drives used
depends on number of copies desired. It is not necessary to always use all drives.
4. Use the scroll buttons to select the command “1. Copy” and press the ENT button. The drives will
automatically close trays and begin the copy process.
5. Once the copy process is completed, the disc trays will eject and the display will read “Copy Result:
Pass X, Fail Y,” with X being the number of successful copies, and Y being the number of failed
copies. To reduce copy failure, please refer to the troubleshooting section of the manual.
Load discs and
Press ENT to execute
Copy
Start copying
Finish
and eject
discs
2. Test
– This command will simulate the copy process and make sure all target discs are usable.
The test process does NOT burn anything to the blank disc(s). A built-in diagnostic algorism is used to
verify the chance of successful copy for each target disc.
To start the Test Process:
1. Power on the machine (if not already on).
2. Eject disc tray of the Source Drive and place the master disc in the designated Source Drive (usually
the top). The “master disc” is the original of which copies are made.
3. Eject disc tray(s) of the Writer Drives and place blank disc(s) on the tray(s). Number of drives used
depends on number of discs to be tested. It is not necessary to always use all drives.
6