ILY SATA DVD/CD Duplicator Controller - Manual (Page 15)

7. Compare Speed: Sets the speed at which the master disc is compared with the copies disc(s).
The speeds for CD are: 1, 2, 4, 8, 10, 12, 16, 20, 24, 32, 36, 40 (default), 44, 48, 52, 56, MAX. The
speeds for DVD are: 1, 2, 2.4, 4, 6, 8, 12, 16 (default), 18, 20 MAX. The compare speed is pre-set
to MAX variable upon drive and media speed.
Press
ENT
or to select CD Compare
Speed and press ENT
or to select DVD Compare speed
and press ENT to finish
8. Skip Read Error: Allows the duplicator to skip uncorrectable read errors on the master DVD or
CD. This feature can be turned ON or OFF.
Press
ENT
or to select mode and
press ENT to confirm
9. Language: Sets the language selection of the display. Available languages are: English (default),
Spanish, Portuguese, and Japanese.
Press
ENT
or to select language
and press ENT to confirm
10. Clear Setup: Resets the duplicator controller back to factory default settings.
Press ENT Select yes and
press ENT to confirm
Press ENT to clear all settings
11. HDD Manager
– This command is for the management of the hard disk drive (HDD) installed in the
duplicator.
Note: This feature is only available on duplicators with a HDD installed. If there is no HDD present in the duplicator,
this feature will NOT show in the menu of commands.
1. Select Image: Allows the selection of the image(s) present on the HDD. The Scroll buttons cycle
through the image(s) on the HDD and the ENT button confirms the selection while the ESC button
cancels the selection. The image(s) are listed in order of which they were loaded.
Press
ENT
or to select image and
press ENT to confirm
13