Start-up and maintenance documentation – FloAire Compact Direct Fired Heater User Manual
Page 29

29
Start-Up and Maintenance Documentation
START-UP AND MEASUREMENTS SHOULD BE PERFORMED AFTER THE SYSTEM HAS BEEN
AIR BALANCED AND WITH THE HEAT ON (Warranty will be void without completion of this form)
Job Information
Job Name
Service Company
Address
Address
City
City
State
State
Zip
Zip
Phone Number
Phone Number
Fax Number
Fax Number
Contact
Contact
Purchase Date
Start-Up Date
Heater Information
Refer to the start-up procedure in this manual to complete this section.
Name Plate and Unit Information
Field Measured Information
Model Number
Motor Voltage
Serial Number
Motor Amperage**
Motor Volts
RPM
Motor Hertz
Burner Differential Pressure
in. w.c.
Motor Phase
Gas Type
Motor FLA
High Fire Inlet Gas Pressure
in. w.c.
Motor HP
Low Fire Manifold Gas Pressure
in. w.c.
Blower Pulley
High Fire Manifold Gas Pressure
in. w.c.
Motor Pulley
Thermostat Set-Point
Belt Number
Temperature Control
Discharge
Gas Type
Space
Min. Btu/Hr
Airflow Direction
Correct
Max. Btu/Hr
Incorrect
**
If measured amps exceed the FLA rating on the nameplate, fan RPM must be reduced to decrease the
measured amps below the nameplate FLA rating.
Maintenance Record
Date
Service Performed
Factory Service Department
Phone: 1-866-784-6900
Fax: 1-919-554-2415