Brother FAX-210 - Manual (Page 35)

26
*****************************
XMT VERIFICATION MM/DDA'Y HH:MM
*****************************
* DESTINATION BROTHER INDUSTRIES *
★ MODE G3 STANDARD *
*
PAGE(S) : 01 *
* RESULT OK *
*******************************************
BROTHER FAX-210
NOTE 1: Only when the transmit report function (XMT VERIFICATION) is set to ON
and your document was properly transmitted, the unit prints out the above
report.
NOTE 2: If a communication error occurred, a communication error report (see p. 53)
is always printed out whether the transmit report function is ON or OFF.
NOTE 3: If the line was busy and your document was not transmitted, neither the
above report nor a communication error report is printed out.
E. Selecting the Password Transmission mode
NOTE: The FAX PASSWORD (refer page 48 SETTING THE FAX PASSWORD) permits
transmission to you by units with the same matching pass-code. Use this feature if you
are part of a closed network or if fax "junk mail" is a problem. Registration of the
passcode is described in ADVANCED OPERATIONS below.
1. Press "6" in the USER SWITCH SELECTION MODE. The LCD will display:
MSG CTR
— AUTO ANS
"•-PASSWORD PASSWORDrOFF
2 . Select the ON or OFF mode using the cursor keys.
P- MSG CTR
— AUTO ANS
"•-PASSWORD
PASSWORD:ON
3. If you press SET, the PASSWORD TRANSMISSION MODE is selected and the
display returns to the USER SWITCH SELECTION MODE.
If you press NEXT, the PASSWORD TRANSMISSION MODE is selected and
the display proceeds to the next user switch (SELECT AUTO ANSWER &
NUMBER OF RINGS).
If you press
STOP, the display returns to the standby mode without
registration.
If you have set Password into ON position, the LCD shows at the proper position in
standby mode.
MSG CTR
— AUTO ANS
"•-PASSWORD 01/01/89 00:00
Important: Unless necessary, leave the Password Transmission OFF to
permit communication with non-Brother units.