Kistler-Morse KM STXPlus - Manual (Page 8)

CHAPTER 2: HARDWARE INSTALLATION
QUICK REFERENCE
Default
Hold the UP, DOWN, and ENTER buttons
while pressing the SW2 reset button.
Changing the Modbus or Serial
Port Address
Both the Modbus Port and the Serial Port
share the same switches to set the port.
Changing from Half-Bridge 3-Wire to
Full-Bridge 4-Wire
Half-bridge will have 12V excitation and
full-bridge will have 10V excitation
automatically.
Enabling Remote Sense
The remote sense is used for 6-wire load
cells or when barriers are used.
Enabling Remote Loop Voltage for the
0-20mA/4-20mA
This switch is moved to external loop power
when a separate power supply will be used
to power the current loop.
2-3