Kistler-Morse KM STXPlus - Manual (Page 20)

APPENDIX B: KISTLER-MORSE ® PROTOCOL SERIAL COMMANDS
APPENDIX B: KISTLER-MORSE ® PROTOCOL SERIAL COMMANDS
INTRODUCTION
This appendix contains the serial commands and Kistler-Morse ® protocol syntax used for serial
communications between the host or master (PC, etc.) and the STXplus. Detailed explanations
and examples of the commands are included. If any parameter or set of parameters that are
transmitted by the master are outside of the acceptable range an ‘N’ will be transmitted back by
the STXplus.
COMMAND TABLE
Table B-1. Kistler-Morse ® Protocol Serial Commands.
B-1