Kistler-Morse KM STXPlus User Manual
Page 3
TABLE OF CONTENTS
CHAPTER 1: INTRODUCTION
1-1
Introduction
1-1
Physical Description
1-1
Functional Description
1-1
Analog Mode
1-1
Filters
1-1
LEDs
1-1
Manual Conventions
1-1
CHAPTER 2: HARDWARE INSTALLATION
2-1
General Information
2-1
Unpacking and Inspection
2-1
Mounting STXplus
2-1
Stand-Alone STXplus with Customer-Supplied Panel/Enclosure
2-1
Stand-Alone STXplus with Kistler-Morse
®
Supplied Enclosure
2-1
Drilling Holes in the Enclosure
2-1
Wiring System
2-2
Wiring Junction Box to STXplus
2-2
Wiring Power
2-2
Wiring Current Output
2-2
External Current Loop Power Supply
2-2
Sealing Openings in Stand-Alone STXplus Enlcosure
2-2
Quick Reference
2-3
Default
2-3
Changing the Modbus or Serial Port Address
2-3
Changing from Half-Bridge 3-Wire to Full-Bridge 4-Wire
2-3
Enabling Remote Sense
2-3
Enabling Remote Loop Voltage for the 0-20mA/4-20mA
2-3
Enabling the Modbus 5.11kΩ Pull-Up Resistor and the 12kΩ End-Of-Line Resistor
2-4
Changing from RS-422 to RS-485
2-4
4-20mA Output
2-4
CHAPTER 3: STAND-ALONE ANALOG CALIBRATION AND SET UP
3-1
Introduction
3-1
Trimming the Current Output
3-1
Trim the 0mA Current Output
3-1
Trim the 4mA Current Output
3-1
Trim the 20mA Current Output
3-1
Setting Up Current Ouptut Operating Mode (0-20mA or 4-20mA)
3-2
Setting Up Input Voltage Range
3-2
Setting Up Channel Enable
3-2
Analog Calibration
3-3
High-Accuracy Calibration
3-3
Starting with an Empty Vessel
3-3
Starting with a Full Vessel
3-4
Calibration by Adding a Known Quantity of Material
3-5
Calibration by Subtracting a Known Quantity of Material
3-5