Brookfield QTS25 Texture Analyzer - Manual (Page 13)

QTS MATERIALS EVALUATION SYSTEM OPERATOR MANUAL
Page 13
• Select set up option: < . Keyboard beeper .>
Press 'ENTER' Beeper
< ....... OFF
ON ...... >
Select using up and down ↑↓ keys then 'ENTER'
• Select set up option: Real time clock . >
Press 'ENTER' "Time" "Day" "Date"
DEL: Alter ENTER: OK
Either press 'ENTER' to accept or 'DEL' to alter and then use 0 - 9 to
key in new time and date.
• Select set up option: < .. No selection .. >
Press 'ENTER'
• Select set up option:
Press ‘ENTER’ OFF =PRINT ON =SERIAL
Select either OFF for printer output to parallel printer port (see page
20 output ‘e’) or ON for printer output to serial or RS232 port (output
‘d’).
Select using the up and down ↑↓ keys then ‘ENTER’.
• Select set up option: < .. Printer LF mode . >
Press 'ENTER'
Line Feed
ON ....... >
< ...... OFF
Select using the up and down ↑↓ keys then 'ENTER'.
Press ABORT display reverts to “QTS Controller Ready”
< .. Monitor load .. >
Select utility: < .. Monitor load .. >
Press 'ENTER' Cell Mon %Offset
-** **.*
Cell Mon is the live reading from the loadcell
% Offset is the amount of zero offset in use. (100% offset = 2Kg)
This mode can be used to check the loadcell linearity and calibration.
Press 'ENTER' to return to :