Brookfield QTS25 Texture Analyzer - Manual (Page 12)

QTS MATERIALS EVALUATION SYSTEM OPERATOR MANUAL
Page 12
h) To obtain an average Gram value by use of the Print key, Select ‘Print on request’
from printer menu.
Now when the print key is pressed, if a printer is connected the normal printed report
will be produced. In addition the LH display will show (No) TEST AV.=(Figure).
If no printer is connected then the LH display will show (No) TEST AV. = (Figure).
If you wish to add tests to same batch and rework statistics then press ENTER,
continue testing until required number of samples are completed, repeat the above. If
you wish to begin a new test from sample No.0 then you will have to enter new batch
number.
Press ABORT to return to “QTS Controller Ready”.
4.8 Configuration Settings
Press 'Configure' key. Use the up and down ↑↓ keys to Select utility:
a) < .. Hardware set-up .. >
Select utility : < .. Hardware set-up .. >
Press 'ENTER'
Select set-up option:
• < . Test/setup utils . >
• < . Keyboard beeper . >
• < . Real time clock . >
• < . No selection . >
• < . Printer Output P/S.>
• < . Printer LF Mode . >
Select using
Select set-up option: < . Test/setup utils .>
Press 'ENTER' Enter Password
Do not attempt to enter this set-up option. The password is only contained in the
service manual. Call your distributor or Brookfield Engineering Laboratories, Inc.
if help is required
Press 'ENTER'. Display returns to start up
message.