Panasonic EY7541 - Manual (Page 5)

Read “the Safety Instructions” booklet
and the following before using.
I. ADDITIONALSAFETY
RULES
1
) Wear ear protectors when using the
tool for extended periods.
2) Be aware that this too! is always in an
operating condition, since it does not have
to be plugged into an electrical outlet.
3) When screwing or driving into walls, floors,
etc., live” electrical wires may be encoun-
tered. DO NOT TOUCH THE HEX QUICK
CHUCK OR ANY FRONT METAL PARTS
OF THE TOOL! Hold the tool only by the
plastic handle to prevent electric shock in
case you screw or drive into a “live" wire.
4) Do NOT operate the Forward/Reverse
lever when the main switch is on. The bat­
tery will discharge rapidly and damage to
the unit may occur.
5) During charging, the charger may become
slightly warm. This is normal.
Do NOT charge the battery for a long peri­
od.
6) When storing or carrying the tool, set the
Forward/Reverse lever to the center posi­
tion (switch lock).
7) Do not strain the tool by holding the speed
control trigger halfway (speed control
mode) so that the motor stops.
8) Young children should be supervised to
ensure that they do not play with the appli­
ance.
Symbol Meaning
V Volts
—
Direct current
Ho No load speed
.../min
Revolutions or reciprocations per
minutes
Ah
Electrical capacity of battery
pack
| ui |A|
Read the operating instructions
before use.
For indoor use only.
n. ASSEMBLY
NOTE:
When attaching or removing a bit or
socket, disconnect battery pack from
tool or place the trigger switch in the
center position (switch lock).
Attaching or Removing
Socket
1, Attaching Socket
Attach the socket by sliding the female
detent on the bottom of the socket to
the square drive on the body.
Make sure the
socket is firm­
ly connected
to the body.
2. Removing Socket
Pull out the socket.
-5 -