Panasonic EY7541 - Manual (Page 15)

ONLY FOR U. K.
IX.
ELECTRICAL PLUG
INFORMATION
FOR YOUR SAFETY PLEASE READ
THE FOLLOWING TEXT CAREFULLY
This appliance is supplied with a moulded
three pin mains plug for your safety and
convenience.
A 3 amp fuse Is fitted in this plug.
Should the fuse need to be replaced please
ensure that the replacement fuse has a rat­
ing of 3 amp and that it is approved by ASIA
or BSI to BS1362,
Check for the ASIA mark ^ or the BSI
mark ^ on the body of the fuse.
If the plug contains a removable fuse cover
you must ensure that it Is refitted when the
fuse is replaced.
If you lose the fuse cover the plug must
not be used until a replacement cover is
obtained.
Areplacement fuse cover can be purchased
from your local Panasonic Dealer,
IF THE FITTED MOULDED PLUG IS UN­
SUITABLE FORTHE SOCKET OUTLET IN
YOUR HOME THEN THE FUSE SHOULD
BE REMOVED AND THE PLUG CUT OFF
AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE
ELECTRICAL SHOCK IF THE CUT OFF
PLUG IS INSERTED INTO ANY 13 AMP
SOCKET.
If a new plug is to be fitted please observe
the wiring code as shown below.
If in any doubt please consult a qualified
electrician.
IMPORTANT:
The wires in this mains lead are
coloured in accordance with the follow­
ing code:
Blue: Neutral
Brown: Live
As the colours of the wire in the mains lead
of this appliance may not correspond with
the coloured markings identifying the termi­
nais in your plug, proceed as follows.
The wire which is coloured BLUE must be
connected to the terminal in the plug which
is marked with the letter N or coloured
BLACK.
The wire which is coloured BROWN must be
connected to the terminal in the plug which is
marked with the letter L or coloured RED,
Under no circumstances should either of
these wires be connected to the earth ter­
minal of the three pin plug, marked with the
letter E or the Earth Symbol
How to replace the fuse; Open the fuse
compartment with a screwdriver and replace
the fuse and fuse cover if it is removable.
Fuse Cover
This apparatus was produced to BS800.
-
15
-