Garmin GNS 430 - Manual (Page 180)

172
Timer has expired —The count down timer has reached zero.
Unit configuration has changed —The GNS 430 has detected a fail-
ure (during initial power up) in its system configuration. Some system
components may be unusable. Try cycling power off and back on. If the
message persists, contact your GARMIN dealer for
assistance.
User card format unknown —A data card has been inserted, but the
format of the card is not recognized.
VLOC has failed —The GNS 430 has detected a failure in its VLOC
receiver. The VLOC receiver is not available and the unit should be
returned to your GARMIN dealer for service.
VLOC is not responding —Internal system-to-system communica-
tion between the main processor and the VLOC receiver has failed.
Operational status of the VLOC receiver is unknown and the unit should
be returned to your GARMIN dealer for service.
VLOC needs service —The GNS 430 has detected a failure in its
VLOC receiver. The VLOC receiver may still be usable, but the unit
should be returned (at your earliest convenience) to your GARMIN
dealer for service.
11 MESSAGES,
aBBREVIATIONS
& nav tERMS
VLOC remote transfer key is stuck —The remote VLOC transfer
switch is stuck in the enabled (or “pressed”) state. Try pressing the
switch again to cycle its operation. If the message persists, contact your
GARMIN dealer for assistance.
VLOC transfer key stuck —The
V
key is stuck in the enabled (or
“pressed”) state. Try pressing the
V
key again to cycle its operation. If
the message persists, contact your GARMIN dealer for assistance.
Waypoint already exists —The name you have entered for a user
waypoint already exists in memory.
Waypoint(s) have been replaced —One or more user waypoints
were updated during a unit-to-unit crossfill operation.
Waypoint memory is full —You have used all 1000 user waypoint
locations in the GNS 430’s memory. Delete unwanted waypoint to
make room for new entries.
WGS 84 datum has been selected —The system map datum was
changed to WGS 84 because the selected map datum was removed
from the current NavData® card (database update), the data card is
missing or the data card has failed.
190-00140-00.indd 172 5/7/2003, 5:18:40 PM