Unitec EZ Trak - Manual (Page 9)

E Z T R A K
Document Number: EZT1001 5
2.3 Installation of the Terminal
The EZ Trak terminal is bolted onto the concrete base. Perform the following steps:
1. Center the EZ Trak terminal on the concrete base. Please note that the
bolt holes are inside the terminal, as shown in the picture the below.
Figure 3. EZ Trak Terminal Base
2. Mark the 4 holes that you intend to drill in order to mount the EZ Trak.
Mark the holes with a marker as the terminal is sitting on top of the
concrete. It is important to keep in mind that the conduit run will need to
protrude through the cutout in the base by at least 3 inches.
Document Title: EZ Trak Installation and Operations Manual