Unitec EZ Trak - Manual (Page 8)

E Z T R A K
Document Number: EZT1001 4
Document Title: EZ Trak Installation Manual
2 Installation
2.1 Mechanical Installation Tools
The following tools are recommended for the typical mechanical installation of this EZ Trak
unit:
6” inch or longer ratchet extension (for optional straight base)
¾” inch deep well socket and socket wrench
Small, thin blade, flat-tip screwdriver
Hammer drill
½” Concrete hammer drill bit
Hammer
Dual-plane Level
50’ foot tape measure
2.2 Electrical Installation Tools
Small, thin tipped, straight screwdriver (1/8” tip, for green Phoenix connectors)
Wire strippers (capable of handling 10-22 AWG wire)
Cable or wire tie wraps
Diagonal cutters
Needle nose pliers
5/16” nut-driver
¼” nut-driver
Phillips-head and flat-head screwdrivers