Bird Technologies 429-83H-01 Series-Manual User Manual
Page 43
TX RX Systems Inc. Manual 7-9439-6 09/03/09 Page 35
Changing The Telnet Port Password
To change the Telnet port password perform the
following steps;
1) Launch HyperTerm on your direct connected
laptop or your remote PC.
2) Navigate to the Change Setup Menu by follow-
ing steps 4 through 8 as discussed in the earlier
section of this appendix (Networked Connec-
tion).
3) At the fourth query in the Server menu “Change
telnet config password (N)” type-in “Y” for yes
and you will be prompted to enter the new pass-
word. Refer to Figure A9.
The password is factory limited to
four characters.
4) Type-in the four characters of the new pass-
word and you will automatically return to the
Change Setup Menu.
5) To finalize your password change choose (9) to
save the new information and exit the Change
Setup Menu. Close the Hyperterm utility pro-
gram.
It is suggested to keep note of this
password change in order to pre-
vent an issue with future connec-
tions through Telnet.
NOTE
NOTE
Figure A9: Changing the Telnet Password.