IKA C 2000 control User Manual
Page 78

&DUH DQG PDLQWHQDQFH
IKA
-WERKE C 2000 basic / control
Ver. 04 08.07
3DJH
c
Loosen the cylinder screws with a straight-bladed screwdriver.
d
Remove the centering ring together with the filling head, pressure spring and piston.
Be careful with the O rings that are now loose.
e
Push the pressure spring onto the new piston or replace the seal washer and insert
both parts into the filling head.
The remainder of the assembly is the same as disassembly in reverse order.
Please note: When reassembling the pieces, make certain the position of
the filling head is correct. The seals must be aligned with the
opposite side of the inner cover.
$IWHU UHDVVHPEO\ FKHFN WKH VHDO RI WKH V\VWHP ZLWK WKH 2
¢
ILOO LWHP LQ WKH 0DLQ
WHQDQFH PHQX
,I WKH DVVHPEO\ ZDV SHUIRUPHG FRUUHFWO\ \RX ZLOO KHDU RQO\ D EULHI KLVVLQJ
QRLVH
'HFRPSRVLWLRQ YHVVHOV
2Q PDLQWHQDQFH RI GHFRPSRVLWLRQ YHVVHOV UHDG WKH & & 2SHUDWLQJ
,QVWUXFWLRQV
1RWHV RQ FOHDQLQJ
When cleaning IKA
devices, use only these cleaning agents that are approved by
IKA
:
7\SH RI GLUW
&OHDQLQJ DJHQW
•
Paint
Isopropanol
•
Construction materials
Water with detergent, isopropanol
•
Cosmetics
Water with detergent, isopropanol
•
Food
Water with detergent
•
Fuels
Water with detergent
•
Substances not named
Please inquire with IKA
1RWH
Electrical devices must not be placed in the cleaning agent for cleaning purposes.
Stainless steel parts can be cleaned with standard commercial stainless steel
cleaning agents, but abrasive agents must not be used.
We also recommend that you wear gloves while cleaning.
The operator is responsible for performing appropriate decontamination measures if
hazardous materials have been spilled on or in the device.
Before using another cleaning or decontamination method than the one recom-
mended by the manufacturer, the user must verify with the manufacturer that the
intended method will not damage or destroy the device.
If the power supply cord is replaced, one of comparable quality should be used.