IKA C 2000 control - Manual (Page 15)

IKA  -WERKE C 2000 basic / control Ver. 04 08.07
3-1
3DJH
7UDQVSRUWDWLRQ VWRUDJH DQG VHWXS ORFDWLRQ
7UDQVSRUWDWLRQ DQG VWRUDJH UHTXLUHPHQWV
During transportation and storage, the system must be protected against mechani-
cal jarring, vibrations, accumulations of dust and corrosive ambient air. Care should
also be taken so that the relative humidity does not exceed 80%.
The device must be completely emptied before being stored and transported.
In case of repair the device has to be cleaned and free from any materials which
may constitute a health hazard.
If you require servicing, return the appliance in its original packaging. Storage pack-
aging is not sufficient. Please also use suitable transport packaging.
6HWXS ORFDWLRQ
When setting up the device, make certain that the applicable state regulations for
operating pressurized containers are adhered to.
A constant ambient temperature is an important prerequisite in ensuring the high
measurement precision of the system. The following conditions must therefore be
maintained at the set-up location:
• No direct sunlight.
• No drafts (for example next to windows, doors, air conditioner outlets).
• The device must be at a sufficient distance from heater and other sources of
heat.
• The minimum distance between the wall and the rear side of the device must be
at least 25 cm.
• The system must not have laboratory hardware such as shelves, wire ducts,
ring lines, etc. installed above it.
• The room temperature must be in the range of 20 °C ... 25 °C (constant).
• The system must be set up on a horizontal surface.
A power supply corresponding to the rating plates of the system components and
the oxygen supply (99.95% pure oxygen, quality 3.5; pressure 30 bar, with a pres-
sure display) must be available to operate the system at the set-up location. A shut-
off valve for the oxygen supply must be installed. Observe the instructions on han-
dling oxygen given in Section 1 "For your safety”.