Gradall G6-42P (91404003_Before 0160004017) Operation Manual - Manual (Page 8)

1.1
Keep all windows and mirror(s) clean. Adjust mirror(s) as required for maximum
visibility, before and during operation.
Never permit diesel engine to run out of fuel. Doing so can cause severe
damage.
DO NOT burn or drill holes in forks. Modifying any part of machine or
attachment affects it’s capacity and/or stability of machine.
Keep head, arms, hands, legs and all other body parts inside the operator’s cab
at all times.
DO NOT approach power lines, overhead or underground cables or other power
sources with any part of your material handler or load unless all local, state/
provincial and federal regulations have been met and the appropriate utility
company’s hotline has been contacted to de-energize the lines.
Whenever leaving the cab, perform standard shut-down procedure:
Standard Shut-Down Procedure
Position the handler in a safe location, apply parking brake, lower forks to
ground, make sure all controls are in “Neutral,” allow engine to run at low idle for 3
to 5 minutes. Stop engine and remove ignition key. Block wheels.
Contact The Gradall Company prior
to welding on machine.
WARNING !