Gradall G6-42P (91404003_Before 0160004017) Operation Manual - Manual (Page 14)

2.4
OUTSIDE THE CAB
9114-3280
EXHAUST SYSTEMS CAN BE HOT.
KEEP AWAY FROM EXHAUST SYSTEM WHEN HOT.
HOT EXHAUST COMPONENTS CAN CAUSE
SEVERE BURNS.
8060-3037-A
PINCH POINT
KEEP OUT
REACHING INTO BOOM
HOLES AND OTHER PINCH
POINTS CAN CAUSE
SERIOUS INJURY
OR DEATH.
Located on right rear frame
P/N 9114-3280
Located on boom head
P/N 9055-3026
Located on left side of boom
P/N 9100-3031
Located on boom
P/N 8060-3037
406 MILL AVE. S.W. NEW PHILADELPHIA, OHIO MADE IN U. S. A.
DO NOT USE PERSONNEL WORK PLATFORM WITHOUT THE
PROPER GRADALL MATERIAL HANDLER/PERSONNEL WORK
PLATFORM CAPACITY CHART DISPLAYED IN CAB.
9055-3033
ATTACHMENT
SERIAL NUMBER
WEIGHT
CAPACITY
HYD. PRESSURE
Located on attachment
P/N 9015-3001
Located on mudguard
P/N 9055-3027
Located on personnel work platform
P/N 9055-3033
406 MILL AVE. S.W. NEW PHILADELPHIA, OHIO MADE IN U. S. A.
THE CAPACITY OF FORKLIFT, ATTACHMENT AND FORK
COMBINATION MAY BE LESS THAN THE CAPACITY SHOWN
ON ATTACHMENT - CONSULT FORKLIFT NAMEPLATE
AND ALSO INSURE FORKS ARE OF PROPER SIZE.
9015-3001
ATTACHMENT
SERIAL NUMBER
WEIGHT
CAPACITY
HYD. PRESSURE
9055-3027 REV. A
READ AND UNDERSTAND THE FOLLOWING PRIOR TO LIFTING PERSONNEL.
WHEN LIFTING PERSONNEL USE ONLY A GRADALL MANUFACTURED PERSONNEL WORK PLATFORM.
DO NOT DRIVE MACHINE WITH PERSONNEL IN PLATFORM.
WHEN PERSONNEL ARE IN PLATFORM REMAIN SEATED IN CAB WITH PERSONNEL
IN DIRECT LINE OF SIGHT.
OPERATE CONTROLS LIGHTLY AND CAUTIOUSLY WHEN LIFTING PERSONNEL.
READ AND UNDERSTAND PERSONNEL WORK PLATFORM USER'S MANUAL BEFORE LIFTING PERSONNEL.
DO NOT USE PERSONNEL WORK PLATFORM WITHOUT THE PROPER GRADALL MATERIAL
HANDLER/PERSONNEL WORK PLATFORM CAPACITY CHART DISPLAYED IN CAB.
FAILURE TO COMPLY COULD RESULT IN SERIOUS INJURY OR DEATH.
9055-3026 REV. A
READ AND UNDERSTAND THE FOLLOWING PRIOR TO LIFTING PERSONNEL.
WHEN LIFTING PERSONNEL USE ONLY A GRADALL MANUFACTURED
PERSONNEL WORK PLATFORM.
ALL PERSONNEL IN PLATFORM MUST WEAR A FULL BODY HARNESS WITH
LANYARD ATTACHED TO A DESIGNATED ANCHORAGE POINT.
READ AND UNDERSTAND PERSONNEL WORK PLATFORM USER'S MANUAL
BEFORE OCCUPYING PERSONNEL WORK PLATFORM.
FAILURE TO COMPLY COULD RESULT IN SERIOUS INJURY OR DEATH.
9114-3290
ATTACHMENT MUST BE SECURED TO MACHINE.
CHECK TO ASSURE QUICK SWITCH PLUNGER
PIN IS FULLY ENGAGED AND LOCKED AFTER
ATTACHMENT CHANGE.
IF PLUNGER PIN IS NOT FULLY ENGAGED
AND LOCKED ATTACHMENT MAY FALL OFF
CAUSING SERIOUS INJURY OR DEATH.
Located on left side of boom head
P/N 9114-3290