Power Soak 27746 PS-200 Owner's Manual - Manual (Page 21)

17
Wash Pump/Heater Will not Operate
If after reviewing the status of the control panel LED’s, there is still an
operating problem, refer to the following troubleshooting guidelines:
• Check to make sure the main electrical power breaker for the Power
Soak system is in the “ON” position.
• Check to make sure the wash sink is filled to the waterline.
• Check to make sure that the liquid level sensors are clean and free
of any debris or grease. The liquid level sensors are located on the
side walls of the wash and sanitizer sinks (the white plastic disc with
a metal center).
If the above trouble shooting procedures do not correct the problem, you
must contact Power Soak Systems, Inc., or an authorized service agency
at 800-444-9624.