Power Soak 27746 PS-200 Owner's Manual - Manual (Page 18)

14
Your system requires minimal, routine preventive maintenance. As such,
the following should be done on a routine basis to ensure that your system
remains reliable:
Daily
Clean the liquid level sensors. These sensors are located on the side walls
of the wash and sanitizer tanks. They are the white plastic discs with metal
centers. Clean the sensor faces thoroughly. If cleaned regularly, a
washcloth and soapy water are all that is required.
Monthly
IMPORTANT: Turn off the power to the unit at the main
breaker prior to performing the following task!
Clean the pump motor fan shroud with a damp, soapy rag. The motor
shroud is the "vented" cover located at the end of the motor (closest to the
control panel). This will prevent grease and dust from accumulating in the
cover's openings, which can obstruct the airflow that cools the motor.
De-lime the wash sink. Simply add a de-liming agent to a sink of warm,
fresh water and run the system overnight.
Ask your chemical sales representative to recommend a specific de-liming
agent.
There are no other preventive maintenance procedures that you will need
to perform on your Power Soak system. You need not be concerned about
greasing the motor bearings, as they are permanently sealed. If you have
any questions regarding the preventive maintenance procedures, please
contact the factory at 800-444-9624.
If the liquid level sensors are not cleaned regularly, the
machine may fail to operate; or it may be possible to
run it without water, which may cause serious damage
to the unit.