Power Soak 33019 PS-50 Owners Manual - Manual (Page 18)

17
Authorized Service Agency Section
Hazard to untrained or unauthorized personnel.
The following procedures are provided for use only by an
authorized service agency. No facility owner, manager,
employee or other unauthorized person should attempt to
perform any of these procedures. To obtain the name of a
recommended service agent in your area, please call the
Metcraft, Inc.
Power Soak Service Department at 800-444-
9624.
When performing troubleshooting procedures, the authorized
service agency will need to open the
Power Soak system's
main electrical enclosure.
Properly close the control panel before reconnecting the
circuits.
Refer to the previous checklist under the "Facility Owner /
Manager Section" before proceeding to the following
checklist items:
Pump does not work
Look For Correction
1 No water in sink Fill sink with water
2 No incoming power to unit Reset customer’s breaker in breaker control panel
3 Loose wires Tighten wires
4 Motor overload tripped See “Overload trips” (Next Section)