Power Soak 33019 PS-50 Owners Manual - Manual (Page 11)

10
Controls and Features - Continued
Loading and Using the Wash Sink
The Power Soak is a “random loading” system. This means that Power Soak
items are not racked for washing. Instead, they are randomly loaded one at a time.
As items are brought to the system and scrapped, they should be immediately
dropped into the wash sink.
If there is no movement of items in the wash sink, or if items are stationary above
the waterline, the system has been overloaded and some items must be removed.
It is very important not to overload the wash sink, as it reduces the effectiveness of
the wash action.
Some pots and pans stack for storage. This is referred to as “nesting” when it
occurs during a
Power Soak wash cycle. Make sure that nested items are
separated and loaded one at a time. Nested items in the wash sink will not be
properly washed.
Power Soak is a “continuous motion” system. This means that the system does
not operate on a set cycle time like cabinet-type washing systems. Instead, during
normal operating hours where washing is required, the system is (normally) left
running. The
Power Soak is energy efficient, and it does not cause excessive
wear to leave it running continuously.
Typically, it takes between three to fifteen minutes to wash items. Some heavily
soiled or burnt-on items may take longer to clean.