beautypg.com

Lokar LS1 Throttle Cable Bracket, Cruise Control Bracket User Manual

Lokar For the car

background image

Building American Quality… With A Lifetime Warranty!

General Installation Notes:

Please read instructions completely before beginning installation.

If you have any questions please call.
Before starting installation, scotch vehicle tires to avoid acci-

dental movement of the vehicle. Do not attempt to install this

product while the engine is running. Disconnect negative battery

cable before beginning installation.
Make sure the engine, transmission, and frame are properly

grounded. We recommend applying anti-seize lubricant to all

aluminum threads before final assembly.

TOLL FREE 1-877-469-7440 • [email protected] • www.lokar.com

®

LS1 Throttle Cable Bracket, Cruise Control Bracket

Installation Instructions

LS1 Throttle Cable Bracket, Cruise Control Bracket

Installation Instructions

INS0047 Rev. 02/14/14

Page 1

© 2008 Lokar, Inc.

There are two styles of LS1 throttle bodies. Make sure you have the
correct throttle cable bracket for your application, as the angles are
different.

1998 – 1999 throttle bodies have a cam assembly that is approximately
3" from top to bottom.

Fig. 1 Use Lokar TCB-40LS1 or TCB-40LS12.

2000 – 2002 GM, and 2004 GTO throttle bodies have a cam assem-
bly that is approximately 3-1/2" from top to bottom.

Fig. 2 Use Lokar

part # TCB-40LS13 or TCB-40LS14.

Refer to Fig. 3 for the component names.

This throttle cable bracket is designed to be used with Lokar Throttle
and/or Cruise Control Cables (not included).

DO NOT loosen the bolt in the bottom of the Lokar throttle cable
bracket or remove the stud from the mounting base. The Lokar throttle
cable stud is precisely indexed to the base, and it can be very difficult
to get it reassembled in the correct position.

Step 1: Remove the existing throttle cable bracket from the intake

manifold.

Step 2: Install the Lokar Billet Aluminum Throttle Cable Bracket to the

mounting boss on the side of the intake manifold using the
M6 x 16mm socket head bolts. Be sure the cable mounting
stud is below the bolts.

Step 3: Remove both of the adjuster nuts from the

cable adjuster on the Lokar Throttle Cable
(not included). Install the small adjuster
nut that is supplied with the LS1 Throttle
Cable Bracket onto the cable adjuster, with
the flat side of the nut facing out towards
the new bracket. The small adjuster nut
will be easier to tighten against the stud
than the larger one.

Install the cable adjuster into the stud with
the small adjuster nut against the flat spot
on the stud. Thread the cable adjuster into
the stud until there is approximately 1/4" of
thread protruding through the stud. Tighten
the small adjuster nut against the stud.

Repeat this process for the cruise control
cable (if applicable).

Step 4: Install the Lokar Throttle Cable and Cruise

Control Cables according to the instructions
included with the Lokar cables. See

Fig. 4

and

Fig. 5 for a completed installation.

1998 - 1999 GM Throttle Body

2000 – 2002 GM, and 2004 GTO Throttle Body

Throttle Cable Only

Throttle Cable Plus Cruise Control Cable

Fig. 1

Fig. 2

Approximately 3"

Approximately 3-1/2"

Stud

Small

Adjuster

Nut

M6 x 16mm

Socket Head Bolts

M6 x 16mm

Socket Head Bolts

Small

Adjuster

Nuts

Stud

Fig. 3