Innotech iSEA User Manual
Page 42

Innotech Service & Event Analyser Installation Instructions
Page 42
© Mass Electronics Pty Ltd 2011
Edition 3.1 dated 26.03.2014
Figure 3-37: Virtual point creation notification
In order to log virtual points, the iSEA connection must first be setup in iComm, following the
procedure specified in the Monitoring section, substituting the final device address with 4. This
fourth device on the iSEA connection will contain all the virtual points setup on this instance of iSEA.
These can then be imported into a Chronicle or Magellan project in the same way as standard device
points.
For details on editing the final device address, see section
3-2.2 Advanced Setup (Tenant Target
.
Figure 3-38: iComm with new virtual device
14. When the Virtual Points manager connects to iComm, a notification will be displayed by
iSEA stating how many virtual points have been created. If the Virtual Points manager gets
disconnected from iComm, iSEA will also show a notification for this event.
To ensure virtual points function correctly, the computer should be setup to automatically login after start-up.