Innotech iSEA - Manual (Page 16)

Innotech Service & Event Analyser Installation Instructions
Page 16 © Mass Electronics Pty Ltd 2011 Edition 3.1 dated 26.03.2014
2-3.1 Stopping and Restarting the iSEA Service
The iSEA service automatically starts when you login to the computer. In the event that iSEA requires
manual stopping and restarting, such as when Innotech software is being installed or upgraded, this
can be achieved from the iSEA shortcuts located in the iSEA program group.
Windows 7
• Click the windows icon on the taskbar.
• Click All Programs and navigate to the
iSEA folder.
• Click either "Start iSEA" or "Stop iSEA" as
required as shown in Figure 2-5.
Windows XP
• Click the Start Button on the taskbar.
• Highlight All Programs and navigate to
the iSEA folder.
• Click either "Start iSEA" or "Stop iSEA" as
required as shown in Figure 2-6.
Figure 2-5: iSEA Program Group in the Windows 7 All Programs Menu
Figure 2-6: iSEA Program Group in the Windows XP All Programs Menu
If you are upgrading your software, the iSEA service must be stopped before upgrading. The iSEA service must
be restarted after upgrading your Innotech software, to ensure correct operation of the Innotech services being
monitored.
IMPORTANT