IEI Integration HDC-3x-Series_SDK_Linux - Manual (Page 27)

HDC-3x Series SDK (Linux)
Page 27
Step 12: The following message shows. Select the codec chip that is used for decoding
the video. Please note that the codec chip options may vary by the installed
capture card. Step 0:
< Device list >
‘Z’<-~~~~~~~~~~~~~~~->Enter
Select following number. (* is current setting)
1 * Codec chip 0
2 Codec chip 1
3 Codec chip 2
4 Codec chip 3
fmb-0?>
NOTE:
To broadcast the encoding video directly, please select “1 Bypass
mode” from Step 5 . When the following message shows, select the
input port that is used for encoding the video. Please note that the input
port options may vary by the installed capture card.
< Device list >
‘Z’<-~~~~~~~~~~~~~~~->Enter
Select following number. (* is current setting)
1 * Input 0
2 Input 1
3 Input 2
4 Input 3
fmb-0?>
1.6.3 Decoding
After configuring decoding settings and video I/O setting, the user can start decoding the
video by following the steps below.
Step 1: Access to the main menu. Type 2 to select “2 Decoding” from the main menu.