GxT Ferret 94 Mulitmeter - Manual (Page 4)

4
Voltage
WARNING!
TO AVOID THE RISK OF ELECTRICAL SHOCK AND INSTRUMENT
DAMAGE, INPUT VOLTAGES MUST NOT EXCEED 1000V DC OR
750V AC RMS. DO NOT ATTEMPT TO TAKE ANY UNKNOWN
VOLTAGE MEASUREMENT THAT MAY BE IN EXCESS OF 1000V
DC OR 750V AC RMS.
NOTE: When taking voltage measurements, this Meter must be
connected in PARALLEL with the circuit, or circuit element under test.
Accuracy
A measurement range determines the highest value the Meter
can measure. Most Meter functions have more than one range.
Being in the right
measurement range
is very important when
measuring. Selection
of a lower range will
move the decimal
point one place and
increase the accuracy
of the reading. The
“1. “ (overload) display
means the range is too
low; select the next
higher range.
To Measure Voltage:
Set the function and
range switch to the desired DC V (or AC V) range. If you do not know
the value of the voltage to be measured, always start with the highest
range.
Insert the Black lead in the COM jack.
PARALLEL CONNECTION
9V
COM VΩ
RED LEAD
BLACK LEAD